Siesta AHQ71CV1 Manuel D'installation page 11

Install Suspension Bolts
1. Install the suspension bolts so that it can support the indoor
unit.
2. Adjust distance to ceiling before installation.
3. Refer to dimension given by Figure N to install the unit.
Installation Ceiling Type
Cover Lock Grille (The moving part protection for user direct touching)
Cover lock grille must be installed as the figure below.
If the unit need to be service, steps below shall be followed:
1. Confirm that the unit had been switched off before servicing the unit.
2. Use screwdriver to unlock the screw on the cover lock grille.
3. Remove the cover lock grille and open the intake grille for the service purpose.
4. Install the intake grille and screw the cover lock grille after service and make sure the unit is proper install.
UNDER CEILING INSTALLATION (AHQ140CV1)
10mm
10mm or less
Screw
Install Indoor Units
1. Insert the suspension bolts into the fi tting of the hanger.
bracket.
2. Set the nuts and washer on both side of the metal fi ttings.
3. Secure it with nuts.
Top Panel Of Unit
Ceiling Board
Intake Grille
Cover Lock Grille
1-9
Figure N