Use The Appliance; Understanding The Air Quality Light; Switching On And Off; Setting The Humidity Level - Philips AC3829 Mode D'emploi

4 Use the
appliance
Understanding the air
quality light
IAI Air quality
level light color
1-3 Blue
4-6 Blue-Purple
7-9 Purple-Red
10-12 Red
The air quality light automatically goes
on when the appliance is switched on,
and lights up all colors in sequence.
In a short time the air quality sensors
select the color that corresponds to the
ambient air quality.

Switching on and off

1
Put the plug in the power socket.
» The appliance beeps.
2
Touch to switch on the
appliance.
» The appliance operates under
the 2-in-1 mode by default with
displayed on the screen.
» When the appliance is warming
up, " " displays on the
screen. After measuring the
particulate matter only in the
air, the appliance shows the IAI
level and operates in the auto
mode by default.
» After measuring the air
quality for approximately
30 seconds, the air quality
sensor automatically selects
the appropriate air quality light
color.
3
• After the appliance is switched
Air quality
level
Setting the humidity
Good
level
Fair
1
Poor
Very poor
• When the humidity level "
• When the target humidity level is
• If you want to increase the humidity
Touch and hold for 3 seconds to
switch off the appliance.
Note
off by the on/off button
plug is still in the power socket, the
appliance will operate under the
previous settings when it is switched
on again.
Touch the humidity button
repeatedly to set the desired air
humidity to 40%, 50%, 60% or "
(fig s).
Note
chosen, the appliance will keep
humidifying the room until the
ambient humidity level reaches
70%RH.
reached, the wick wheel will stop
rotating. It will start rotating again
when the humidity drops below the
target level.
level quickly, you can select a higher
fan speed.
, if the
"
" is
EN
9