Replacing The Active Airclean 50 And Hepa Airclean 50 Exhaust Filters; Replacing One Type Of Exhaust Filter With Another; When Changing The Filter, Please Note; When To Change The Thread Catchers - Miele HS11 Instructions D'utilisation

en-US
 Replace it with a new AirClean ex‐
haust filter.
If you wish to fit an Active AirClean
50 or HEPA AirClean 50 exhaust fil‐
ter, see "Replacing one type of ex‐
haust filter with another."
 Close the filter frame.
 Close the dust compartment lid.
Replacing the Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(Fig. 33 + 34)
Do not use more than one exhaust fil‐
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
 Press the exhaust filter change indi‐
cator (Fig. 13).
After approx. 10 - 15 seconds, a thin
red stripe will appear in the left hand
side of the display (Fig. 14).
If you wish to insert an AirClean ex‐
haust filter, see "Replacing one type
of exhaust filter with another".
 Close the dust compartment lid.
20
Replacing one type of exhaust filter
with another
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (Fig.
10):
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Do not use more than one exhaust fil‐
ter at a time.
When changing the filter, please
note:
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that
you remove the filter frame before
you fit the new exhaust filter.
In addition, you must activate the ex‐
haust filter change indicator (Fig. 13).
2. If you wish to replace exhaust filter b
or c instead of a, so it is essential
that you also fit it in a filter frame *
(Fig. 32).
* Filter frame - see "Optional acces‐
sories."
When to change the thread catch‐
ers?
The thread catchers on the suction inlet
to the floor brush can be replaced.
Check them from time to time and re‐
place them if the pile has worn down.

Replacing the thread catchers

(Fig. 35 + 36)
 Use a suitable screwdriver to remove
the thread lifters from the slots.