When To Replace The Exhaust Filter; How To Replace The Airclean Exhaust Filter; Replacing The Airclean Plus 50, Active Airclean 50 And Hepa Airclean 50 Exhaust Filters; Replacing One Type Of Exhaust Filter With Another - Miele Compact C1 Mode D'emploi

en

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
Replace this filter every time you start a
new packet of dustbags. Every packet
of original Miele dustbags contains one
AirClean exhaust filter. Multipacks con-
tain four AirClean filters (only available
in selected countries).
b AirClean Plus 50 (light blue)
Replace this filter after approx. one
year. Make a note of the date on the fil-
ter.
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
Replace this filter when the exhaust fil-
ter timestrip® change indicator is com-
pletely red (dia. 17). The indicator lights
up after approximately 50 hours of op-
eration, which is equivalent to about a
year of average use. You can continue
vacuuming when the light comes on.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.
How to replace the AirClean exhaust
filter (dia. 34 + 35)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Open the filter grille.
 Grasp the used AirClean filter by the
clean, unsoiled section and take it
out.
 Replace it with a new AirClean filter.
42
If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA
AirClean 50 filter, see "Maintenance -
Replacing one type of exhaust filter
with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the AirClean Plus 50,
Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making it
sure it goes in properly, then push it
down into position.
 If you are using exhaust filter c or d,
press the exhaust filter timestrip®
change indicator (dia. 15).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display for both exhaust filters
(dia. 16).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 12)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters: