Installation Method Of Space Isolator - H.Koenig SWR28 Manuel D'utilisation

Installation method of Space Isolator:

1. The Space Isolator is placed at the entrance to the stair or room generally.
2. You can place the Space Isolator at proper position to stop the Cleaner passing through
some places.
3. Remove obstacles from the area you want to block in front of the Space Isolator as much
as possible for fear of poor effect.
1. Open the battery cover before using, place 2x"D" batteries (not included) into
the box correctly. Pay attention to the polarity or the Space Isolator will not
work.
2. The battery consumption duration is related to the selected transmitting
distance and working duration, please select proper transmitting distance
and low transmitting power to save the battery, so don't forget to turn off the
toggle switch while unused.
3. There will be some difference in the direction, transmitting infrared signal of
the Space Isolator and receiving distance of the Cleaner due to environmental
impact and movement of the Cleaner during the actual using. The difference
above may vary based on the actual environment and different battery power
of the Cleaner and Space Isolator.
1. The Space Isolator should be placed at the same level of the ground where the
Cleaner is running.
2. You should check whether the Cleaner can pass the Space Isolator while
using it first.
The distance between the Space Isolator and recharger should be more than
3m, or there will be interference.
4. The Docking Station should not be installed within the signal scope of the
Space Isolator.