Problem
Abnormally
elapsing time on
the display.
Programme in-
active.
Drying cycle too
short.
Drying cycle too
6)
long
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selec-
tion of the new programme. Push the Start/Pause button. Does not operate? - contact the service centre
and give the error code.
2) Follow the programme description — see PROGRAMME TABLE
3) See chapter CARE AND CLEANING
4) Only dryers with the Dry Plus option
5) See HINTS AND TIPS chapter
6) Note: After maximum 5 hours the drying cycle ends automatically.
13. TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
Possible cause
1)
The time to end is calculated on
the basis of the volume and damp-
ness of the laundry.
The water container is full.
Too small laundry volume.
The laundry is too dry.
The filter is clogged.
Too high volume of the load.
The laundry not spun sufficiently.
Too low or too high room temper-
ature - this is not the appliance
malfunction.
The automatic procedure — this is
not the appliance malfunction.
Drain the water container, push
the Start/Pause button.
Do the selection of time pro-
gramme. The time value must be
related to the load. To dry 1 item
or small quantities of the laundry
we recommend to use short times.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry)
Clean the filter.
Obey the maximum load volume.
Spin correctly the laundry.
Ensure a room temperature higher
than +5°C and lower then +35°C.
850 x 600 x 600 mm (maximal 640 mm)
1090 mm
950 mm
850 mm (+ 15 mm - feet regulation)
118 l
8 kg
230 V
ENGLISH
21
Remedy
3)