Startup - Telic STD32 Mode D'emploi

As described in figure 1 the STD 32 has four pairs of screw
terminals. Two pairs (In1, In2) are inputs to two optocouplers.
The other two pairs (Relay1, Relay2) are outputs (switches) of
the 2 relays of the STD32.
PWR: connect the supply voltage of the STD32 here.
ANT: connect the GSM antenna here.
When the engine is booked into the GSM network the GSM
LED is flashing once every 2 seconds.
The status LEDs show the status of the inputs and outputs. L1
and L2 are on if the corresponding relay is activated. L3 and L4
signal the status of the optocoupler inputs IN1 and IN2.
Please observe the maximum output voltage of the relays and
the maximum input voltage of the inputs! In the following
chapter „Startup" you will find further information on this.

Startup

You need an activated SIM card of a GSM network provider.
The PIN of this card has to be set to „0000". To change the PIN
you can use a common mobile phone. The instructions how to
change the PIN are described in the manual of your mobile
phone.
29