KitchenAid 720-0819 Instructions D'installation Et Guide D'utilisation Et D'entretien page 23

Prepare the Grill for Lighting
1. Open the hood completely. Do not light burners with the hood
closed.
2. Make sure control knobs are turned to OFF. The drip pan must be
in place and pushed all the way to the back.
A. Drip pan
Turn the Gas Supply On
1. For using a 20 lb LP gas fuel tank: Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not light. If
your grill does light, the flames will be low and will not heat properly.
Turn tank valve and all control knobs off and wait 30 seconds. After
shutting off the tank, very slowly open tank valve and wait 5
seconds before lighting.
2. For outdoor grills using gas supply source other than a 20 lb LP
gas fuel tank:
Open the manual shutoff valve in the gas supply line. The valve is
open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
Lighting the Grill
IMPORTANT: If burner does not light immediately, turn the burner
knob to OFF and wait 5 minutes before relighting.
1. Open the hood completely. Do not light burners with the hood
closed.
2. Do not lean over the grill.
3. Select the burner you want to light. Push in and turn the grill
burner control knob to IGNITE/HIGH or IGNITE/ON, while
continuing to hold it in.
4. You will hear the ''snapping'' sound of the spark. When burner is
lit, release the knob. Turn knob to desired setting.
5. Repeat for each of the other burners as needed.
IMPORTANT: If burner does not light immediately, turn the burner
knob to OFF and wait 5 minutes before relighting.
A
Manually Lighting Main Burners
1. Open the hood completely. Do not light burners with hood
closed.
2. Do not lean over the grill.
3. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
4. Strike the match to light it.
5. Guide the lit match between the grill grate.
6. Push in and turn the burner knob to IGNITE/HIGH for the
burner closest to the lit match. The burner will light
immediately. When burner is lit, turn knob to desired setting.
7. Repeat steps 2 trough 6 for each main burner.
8. Remove match and replace manual lighting extension inside
the cabinet door.
IMPORTANT:
If burner does not light immediately, turn the burner knob to
OFF and wait 5 minutes before relighting.
If any burners do not light after attempting to light them
manually, contact the Customer Service Center. See the
'' Assistance or Service'' section.
23