Publicité
Les langues disponibles
Les langues disponibles
014584
Overheat protection for tool
When
the
tool
is
automatically and the indicator blinks about 60 seconds.
In this situation, let the tool cool before turning the tool
on again.
Overheat protection for battery
When the battery is overheated, the tool stops
automatically and the battery indicator lights up about
60 seconds. The tool does not start even if pulling the
switch trigger. In this situation, let the battery cool before
turning the tool on again.
NOTE:
The battery overheat protection works only with a
battery cartridge with a star marking.
1
012128
Overdischarge protection
When the remaining battery capacity gets low, the
indicator blinks. By further use, the tool stops and the
indicator lights up about 60 seconds. In this situation,
charge the battery cartridge.
Using the trigger lock
CAUTION:
When not in use or after operating the tool, always
•
lock the trigger with the trigger lock.
A
2
014582
1. Battery indicator
1
overheated,
the
tool
1. Star marking
1. Trigger lock
1
2. Press to Lock
position
3. Press to Free
position
3
The tool has trigger lock to avoid accidents by an
unintentional start. The trigger lock makes the trigger
unmovable and let the tool cause no firing.
To lock the trigger, set the lock button in the "LOCK"
position.
Before nailing, set the lock button in the " FREE"
position. When not in use, always set it in the "LOCK"
position and remove the battery cartridge from the tool.
Nailing mode selection
stops
3
014618
The tool has two different nailing modes. Select the
desired nailing by the mode selecting button. For more
detail, see the section "OPERATION".
Intermittent nailing (sequential mode)
This mode suits for driving a nail carefully and
accurately.
Continuous/ intermittent nailing (continuous mode)
When the tool is set to this mode, you can choose either
continuous or intermittent nailing by sequences of the
trigger operation.
Adjusting the nailing depth
WARNING:
Always make sure that your fingers are not placed
•
on the trigger, and the battery cartridge and nails
are removed.
A
A
014601
To get shallower depth, turn the adjuster to A direction
as shown in the figure. To get deeper depth, turn the
adjuster to B direction.
Do not turn the adjuster too much, or the adjuster may
get stuck.
6
1. Mode selecting
1
2
button
2. Sequential
mode
3. Continuous
mode
1. Adjuster
1
B
B
Publicité
