Maintenance; Decommissioning; Spare Parts Service; Warranty Conditions - Schneider Airsystems SGS 315-1 Notice D'utilisation D'origine

2.5

Maintenance

Impact wrench/
Ratchet screwdriver Drive motor lubri-
cation:
Regular lubrication is required!
Apply oil via a maintenance unit with a mist
oiler.
Without mist oiler: oil daily by hand via the
plug nipple (item 01).
For long breaks in operation, also oil via
plug nipple (item 01) using special oil for
compressed air tools.
Impact wrench
Lubricate the impact mechanism ap-
prox. every 48 working hours:
If available:
apply grease via grease nipple (item 10)
approx. every 48 working hours.
Impact wrench
Impact mechanism lubrication
2-3 times a year with oil / grease:
1. If fitted:
Loosen the oil filler screw (item 09).
2. Fill with approx. 5-10 drops of oil.
3. Tighten the oil filler screw.
Alternatively:
1. Loosen the screws (item 13) and open
the housing (item 08)
Fig. 4a.
2. Remove the
(Fig. 4b).
3. Lubricate the impact mechanism with oil
/ grease (Fig. 4c).
4. Fit the impact mechanism in reverse or-
der.
Close the housing (item 08) and tighten
the screws (item 13).
as shown
impact mechanism
Ratchet screwdriver
times a year with oil:
1. If fitted:
Lift the rubber protection (item 12).
2. Lubricate the drive bush, drive shaft and
ratchet drive housing through the re-
cesses in the front of the machine or the
via the switch-over button (item 04) as
shown in Fig. 5a.
2.6

Decommissioning

Storage: Clean, dry, dust-free, not below
5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.
2.7

Spare parts service

Visit our website
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
2.8

Warranty conditions

Basis for warranty claims: complete unit
in original condition/proof of purchase.
According to legal provisions, you re-
ceive the following warranty against
in
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
Excluded from warranty claims: Wear or
expendable parts, improper use, overloading
/ incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
RAS - SGS
lubrication 2-3
www.schneider-airsys-
II /9
GB