AEG SCB41811LS Notice D'utilisation page 29

Problem
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
8.2 Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from
the mains socket.
1. With your fingers, spread slightly
both sides of the transparent cover
to unhook them and detach the
cover pulling it in the direction of the
arrows.
Possible cause
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
2. Replace the lamp with the one that
has identical characteristics and is
specifically designed for household
appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
1
2
1
29