Hornbach 10178638 Manuel D'installation Et De L'utilisateur page 139

Remote control holder 1x
Drill two holes and fi x the plas-
tic support of the remote con-
trol holder with the plugs and
screws. Slide the holder onto
the plastic support and insert
the remote control.
Inserting the remote control
battery
Slide out the battery support
from the back of the remote
control. Place the delivered
CR2430 (Lithium) battery with +
(plus pole) facing upwards into
the battery holder and reinsert
the battery support.
Setting the extension limit
Press button to extend the
awning to the set limit.
To increase the expansion of the
awning, insert the adjusting pin
into the red worm and rotate in
the "+" direction. Stop rotating
when the awning has reached the
required extension.
To decrease the expansion of the
awning, press the button, rotate
the red worm in the "-" direc-
tion, fully retract the awning and
expand it again to the new limit.
Repeat until the awning reaches
the required extension.
Setting the retraction limit
Press button to retract the
awning. If the awning does not
retract completely, extend it to
insert the adjusting pin into the
white worm. Rotate in the "+"
direction. Test retraction. Repeat
until awning closes satisfacto-
If the motor still operates after
awning is completely retracted,
rotate the white worm in the "-"
direction. Ensure that the motor
sound stops immediately after
awning is closed completely.
7
8
rily.
ENGLISH | 139