AEG FAVORIT 78600 VI1P Notice D'utilisation page 30

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

30
www.aeg.com
• The display shows the current
setting: e.g.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.
6.4 Use of rinse aid and multi-
tablets
When you activate the option Multitab,
the rinse aid dispenser continues to
release rinse aid. However you can
deactivate the rinse aid dispenser. In this
= level 5.
again and again to change
,
,
.
,
continues to
= level 4.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
again and again to change
case the drying results may not be
satisfactory.
With the rinse aid dispenser deactivated,
the rinse aid indicator is always off.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
2. Press
3. Press
and
until
The rinse aid indicator goes off.
4. Press the on/off button to confirm
and
6.5 Acoustic signals
and
go
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
,
start to flash and the display is blank.
.
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting:
= rinse aid dispenser
activated.
to change the setting.
= rinse aid dispenser deactivated.
the setting.
hold simultaneously
and
until
,
and
,
and
go
continues to
and
until

Publicité

Table des Matières
loading

Table des Matières