Specifi Cations; Packaging - Labelling - BaByliss G940E Mode D'emploi

been exposed to the sun for at least four weeks. A sun screen with a high protection factor (protection
factor of 50+) could be some help, as well as clothes that cover the area to be treated. Moreover, the
area to be treated should be washed with soap and water beforehand and then shaved clean of hair.
17. How do I take care of the treated area after using the Homelight epilator ?
The area treated with the Homelight epilator may be cleaned and cared for with well-known skin care
products. Specifi c precautions should be taken to avoid unprotected exposure to the sun. Sun screens
with a higher protection factor (protection factor of 50+) and long clothing are good protection
against the sun.
18. Should I remove hair before, between and after treatments?
No, do not remove hair before, during or after treatments. The hair will fall out on its own naturally and
gradually. This stage may last up to two weeks.
11. Specifi cations
Point of impact, Specs
Repetition rate
Light intensity
Wavelength
Required electrical installation

12. Packaging - Labelling

Waste electrical and electronic equipment
CE Marking
Following the usage guidelines
Moisture protection: ordinary
This appliance is not intended to be used near a fl ammable mixture of anaesthetic and air or with oxygen or nitrous
oxide.
3.0 x 1.0 cm = 3.0 cm 2
At level 1, a pulse every 1,6 second.
At level 5, a pulse every 3,5 seconds
At level 1 : 2 J/cm²
At level 2 : 3 J/cm²
At level 3 : 3.5 J/cm²
At level 4 : 4 J/cm²
At level 5 : 4.5 J/cm
550 - 1200 nm (without using the face fi lter)
600 - 1200 nm (with the use of the face fi lter)
100 - 240 VAC, 4A
63