Toolland DTB10003 Mode D'emploi page 6

5. Charging the Battery
1. Remove the battery from the battery compartment and connect to the charger.
2. Connect the charger to the mains. The LED will burn red to indicate the battery is
charging.
3. When the LED burns green, the battery is fully charged. Disconnect the charger
from the mains to avoid overcharging. Install the battery in the battery
compartment.
a
6. Assembly
1. Open the battery compartment, install the fully-charged battery and close the
compartment.
2. Screw the lance onto the trigger.
V. 01 – 25/03/2020
battery is charging
DTB10003
b
6
battery fully charged
©Velleman nv