Troubleshooting; Scrapping - KENT 26D Instructions D'utilisation

INSTRUCTIONS FOR USE

TROUBLESHOOTING

TROUBLE
The motors do not work; no warning
light turns on
The machine does not move
At the machine start-up, the
warning light (4, Fig. B) of the
switch flashes and the brushes do
not work
The warning lights (7, Fig. B) flash
simultaneously
The brushes do not work, the red
warning light (7c, Fig. B) is on
Insufficient dirty water vacuuming
Insufficient solution flow to the
brushes
Marks caused by the squeegee
NOTE
The machine cannot operate without the battery charger. In case of battery charger malfunction, contact an
authorized Service Center.
For further information, refer to KENT Service Centers.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following components:
– Batteries
– Brushes
– Plastic hoses and components
– Electrical and electronic components
CAUTION!
Removed components must be disposed of according to the law in force.
18
POSSIBLE CAUSE
Disconnected battery connector (4, Fig. J)
Completely discharged batteries
The machine has been turned on with the ignition
key (12, Fig. B) while pressing the pedal (3, Fig. C)
The machine has been turned off without lifting the
brush deck
Brush motor overload
Discharged batteries
Full recovery water tank (15, Fig. I)
Clogged vacuum grid (5, Fig. I) or stuck closed
float
Hose (11, Fig. C) disconnected from the squeegee Connect
Dirty squeegee (12, Fig. C), or worn or damaged
squeegee blades
Incorrectly closed tank cover, or damaged gasket
(2, Fig. I)
Empty solution tank
Dirty solution filter (2, Fig. E)
Dirty tank (16, Fig. I), clogged output hole
Debris under the squeegee blades
Worn, chipped or torn squeegee blades
The squeegee has not been balanced with the
handwheel (16, Fig. C)
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11
REMEDY
Connect
Charge
Turn the machine off and then turn it on without
pressing the gear pedal
Wait for the deck to lift before turning on again the
brushes by pressing the switch (4, Fig. B)
Use less aggressive brushes suitable for the floor
to be cleaned or avoid working with extra pressure
function turned on
Charge
Empty
Clean
Clean the squeegee or overturn/replace the blades
Correctly close the cover or clean/replace the
gasket
Fill
Clean
Clean
Clean
Overturn or replace
Balance