Machine Working Hour Check; Squeegee Cleaning; Squeegee Blade Check And Replacement - KENT 26D Instructions D'utilisation

INSTRUCTIONS FOR USE

MACHINE WORKING HOUR CHECK

1. Insert the ignition key (12, Fig. B) and turn it to "I".
2. In the first 5 seconds of machine operation, the display
(8, Fig. B) shows the total number of working hours
(scrubbing/drying) performed by the machine.
Turn the ignition key (12, Fig. B) to "0".

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades
must be in good conditions in order to get a
good drying.
CAUTION!
It is advisable to wear protective gloves when
cleaning the squeegee because there may be
sharp debris.
1. Drive the machine on a level floor.
2. Insert the ignition key (12, Fig. B) and turn it to "I".
3. Lower the squeegee (12, Fig. C) by pressing the switch
(6, Fig. B).
4. Turn the ignition key (12, Fig. B) to "0".
5. Disconnect the vacuum hose (11, Fig. C) from the
squeegee.
6. Loosen the handwheels (15, Fig. C) and remove the
squeegee (12).
7. Wash and clean the squeegee. In particular, clean the
compartments (1, Fig. F) and the hole (2) from dirt and
debris. Check the front blade (3) and the rear blade (4)
for integrity, cuts and tears; otherwise replace them.
8. Assemble in the reverse order of disassembly.
14
SQUEEGEE BLADE CHECK AND
REPLACEMENT
1. Clean the squeegee as shown in the relevant paragraph.
2. Check that the edges (5 and 12, Fig. F) of the front (17,
Fig. C) and rear blades (18) lay down on the same level,
along all their length; otherwise adjust their height
according to the following procedure:
– Disengage the fastener (6, Fig. F) and loosen the
wing nuts (7) to adjust the rear blade (4); then tighten
the wing nuts and engage the fastener.
– Loosen the wing nuts (8, Fig. F) to adjust the front
blade (3); then tighten the wing nuts.
3. Check the front blade (3, Fig. F) and the rear blade (4)
for integrity, cuts and tears; otherwise replace them
according to the following procedure. Check that the
front corner (9) of the rear blade is not worn; otherwise,
overturn the blade to replace the worn corner with an
integral one. If the other corners are worn too, replace
the blade according to the following procedure.
– To replace (or overturn) the rear blade (4) disengage
the fastener (6), unscrew the wing nuts (7) and
remove the retaining strip (10). Install the blade in the
reverse order of removal.
– To replace the front blade (3) unscrew the wing nuts
(8) and remove the retaining strip (11). Install the
blade in the reverse order of removal.
After replacing (or overturning) the blades, adjust the
blade height as shown in the previous step.
4. Install the squeegee (12, Fig. C) and screw down the
handwheels (15).
5. Connect the vacuum hose (11, Fig. C) to the squeegee
(12).
6. If necessary, adjust the squeegee balance adjusting
handwheel (16, Fig. C).
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11