Unpacking/Delivery - KENT 26D Instructions D'utilisation

INSTRUCTIONS FOR USE
– Always protect the machine against the sun, rain and
bad weather, both under operation and inactivity
condition.
– Do not use the machine as a means of transport.
– Do not use the machine on slopes with an inclination
higher than 16%.
– Do not allow the brushes to operate while the machine is
stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a
water one.
– Do not bump into shelves or scaffoldings, especially
where there is a risk of falling objects.
– Do not tamper with the machine safety guards and follow
the ordinary maintenance instructions scrupulously.
– Do not remove or modify the plates affixed to the
machine.
– In case of machine malfunctions ensure that these are
not caused by a lack of maintenance. Otherwise,
request assistance from the authorized personnel or
from an authorized Service Center.
– If parts must be replaced, require ORIGINAL spare parts
from a Dealer or Authorized Retailer.
– To ensure proper and safe operation of the machine,
have the scheduled maintenance, detailed in the
relevant chapter of this Manual, performed by the
authorized personnel or an authorized Service Center.
– The machine must be disposed of properly, because of
the presence of toxic-harmful materials (batteries, etc.),
which are subject to standards that require disposal in
special centers (see Scrapping chapter).
– Do not allow any object to enter into the openings. Do
not use the machine if the openings are clogged. Always
keep the openings free from dust, hairs and any other
foreign material which could reduce the air flow.
– This machine cannot be used on roads or public streets.
– Pay attention during machine transport, when
temperature is below freezing point, because the water
in the recovery tank or in the hoses could freeze and
seriously damage the machine.
– Use only brushes and pads supplied with the machine or
specified in this Manual. Using other brushes or pads
could reduce safety.
– When WET batteries are installed on the machine, do
not tilt the machine for more than 30° from the horizontal
plane to prevent the highly corrosive acid from leaking
out of the batteries. If the machine must be tilted to
perform any maintenance procedures, remove the
batteries.
4

UNPACKING/DELIVERY

To unpack the machine, carefully follow the instructions on
the packing.
When the machine is delivered, check that the packing and
the machine were not damaged during transportation. In case
of visible damages, keep the packing and have it checked by
the Carrier that delivered it. Call the Carrier immediately to fill
in a damage claim.
Check that the machine is equipped with the following
features.
1. Technical documents:
– Scrubber-dryer Instructions for Use Manual
– Electronic battery charger Manual
– Scrubber-dryer Spare Parts List
2. No. 2 lamellar fuses
3. No. 5 shims for 6V battery housing
4. One 2 mm-key for socket screws
Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(2)2006-11