Installing/Replacing The Lens - EuroLite Multi Lens Spot Série Mode D'emploi

During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one GKV 240V/600W G-9.5 lamp.
Procedure:
Step 1: Open the lampholder cover by loosening the fixation screw.
Step 2: If replacing the lamp, remove the old lamp from the spot.
Step 3: Insert the lamp in the lampholder.
Step 4: Insert the lampholder and close the device.

Installing/Replacing the lens

(EUROLITE ML-64 and EUROLITE ML-64 Pro)
The lenses should be inserted with the bulge facing outwards. This will ensure the following properties:
1. The mounting clamp for the lenses engages with the groove on the lens and in this way prevents the
unintentional falling out of the lens.
2. In case of a possible cracking of the lens, the bulge direction helps prevent single pieces from falling out.
3. The lens has a filter function with regard to the infrared constituent in light. The reflective effect towards
the housing rear panel can only function if the lens has been installed correctly.
Please use this device only with installed color filter frames!
Do not operate this device with opened housing!
17/37 00037161.DOC, Version 2.1