Urmet 1096 Manuel D'utilisation page 14

Product specifications may be subject to change without prior notice.
ACCESSORIES PROVIDED
•
N°1 guide pattern (drilling template).
•
N°1 Allen wrench
•
Instruction manual.
ø Important note: Accessories may be changed without prior notice.
INSTALLATION SPECIFICATIONS
•
Avoid pointing the lens directly towards the sun or intense sources of light also when the camera is
off. The subject must not be backlit.
•
Some lighting systems (e.g. coloured fluorescent lights) may false the colours.
•
Arrange a suitable circuit breaker and fuse upstream of the devices.
•
Make sure that the rating plate data correspond to the power specifications before connecting the
device to the mains.
INSTALLATION PRECAUTIONS
•
Though the device has an IP66 protection grade, there are particular environments (such as
seashores, harbours, wharves, etc.) that can accelerate corrosion of external parts. Also installation in
very dusty environments (quarries, mines, dusty materials, etc.) can compromise the optimal
operation.
•
To prevent device overheating, place it in a well aired position.
•
For the same reason, the device must not be installed near heat sources as radiators or warm air
ducts, in places where it is directly exposed to sun irradiation or in rooms with excessive dust
accumulation, subject to mechanical vibrations or impacts.
•
Consider the device operating temperature range (0°C÷+50°C) before choosing the place for
installation. Do not install the unit over another heating device.
•
Do not power the device on immediately after moving it from a cold place to a warm one and vice
versa. As a general rule, wait for three hours: the device needs this time to adapt to a new
environment (temperature, humidity, etc.).
INSTALLATION
Make sure that no units are powered before starting the installation procedure.
POSITIONING AND CONNECTIONS
1. Loosen the locking ring on the bracket and the screw
2. In the case of the minidome, rotate the body of the minidome for the chosen shot.
In the case of vandal dome, undo the dome support and turn the camera body for the
chosen shot, then close the dome again.
3. Once made, firmly block.
4. Important note: In order to avoid serious damages to the connection cable, avoid
rotating repeatedly and excessively the camera fixed to the bracket.
5. Connect the video output to the utility.
6. Power the camera.
VIDEO OUTPUT QUICK SELECTION
The camera has the possibility to use 4 different video outputs, to be selected through 2 dip
switches placed at the end of the connection table.
14
DS1096-119A