Publicité
Les langues disponibles
Les langues disponibles
Operation with abrasive cut-off /
diamond wheel
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
WARNING:
NEVER use cut-off wheel for side
grinding.
WARNING:
Do not "jam" the wheel or apply
excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel
increases the loading and susceptibility to twisting
or binding of the wheel in the cut and the possibility
of kickback, wheel breakage and overheating of the
motor may occur.
WARNING:
Do not start the cutting operation
in the workpiece. Let the wheel reach full speed
and carefully enter into the cut moving the tool
forward over the workpiece surface. The wheel
may bind, walk up or kickback if the power tool is
started in the workpiece.
WARNING:
During cutting operations, never
change the angle of the wheel. Placing side pres-
sure on the cut-off wheel (as in grinding) will cause
the wheel to crack and break, causing serious per-
sonal injury.
WARNING:
A diamond wheel shall be oper-
ated perpendicular to the material being cut.
Mount the inner flange onto the spindle.
Fit the wheel / disc on the inner flange and screw the
lock nut onto the spindle.
1
2
3
► 1. Lock nut 2. Abrasive cut-off wheel / diamond
wheel 3. Inner flange 4. Wheel guard for abrasive
cut-off wheel / diamond wheel
For United States and Canada
► 1. Lock nut 2. Outer flange 78 3. Abrasive cut-off
wheel / diamond wheel 4. Inner flange 78 5. Wheel
guard for abrasive cut-off wheel / diamond wheel
Operation with wire cup brush
Optional accessory
CAUTION:
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
4
► 1. Wire cup brush 2. Urethane washer (included
depending on the country)
Remove the battery cartridge and place the tool upside
down allowing easy access to spindle.
Remove any accessories on spindle. Mount urethane
washer (included depending on the country) then thread wire
cup brush onto spindle and tighten with supplied wrench.
NOTICE:
which causes over bending of wires when using
brush. It may lead to premature breakage.
13 ENGLISH
ø45
1
ø78
2
3
ø78
4
Check operation of brush by run-
Do not use brush that is damaged,
Avoid applying too much pressure
5
1
2
Publicité
