Setup; Setup Location Requirements; Legs/Feet - Caso Germany WineSafe 12 black Mode D'emploi

12.5 Setup

12.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
•
Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded.
•
Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
•
Ambient temperature below 0°C or above 38°C will hinder the
performance of the appliance.
•
This unit is not designed for use in a garage or any other outside
installation.
•
Do not set up the device in a hot, wet or extremely damp environment or
near flammable material.
•
The device requires an adequate flow of air in order to operate correctly.
Leave a clearance of 8 cm around the appliance.
•
Do not cover up any openings on the device and do not block these off.
•
The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.
•
For energy saving reasons please ensure that the door is closed when
the appliance is turned on.
12.5.2

Legs/feet

There are FOOT (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
caso WineSafe 12 black 31