General Information; Checks Before Installation - Hoshizaki HNC-120BE-L Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
I. GENERAL INFORMATION
1. CONSTRUCTION
Circuit Breaker
Condenser
Air Filter
Louver
Sliding Glass Door
*Note: Always attach the two plugs to the drain holes located in
the showcase.
II. INSTALLATION AND OPERATING
INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

* Visually inspect the exterior of the shipping container,
and any severe damage noted should be reported to
the carrier.
Remove shipping carton, evaporator spacer,
tape(s) and packing. If packing material is left in
the showcase, it will not work properly.
Remove shipping tape holding the door.
* Remove the package containing accessories.
* See the nameplate on the rear of the showcase, and
check that your voltage supplied corresponds with
the voltage specified on the nameplate.
2. LOCATION
This showcase is not intended for outdoor
use. Normal operating ambient temperature
should be within 10°C to 30°C. Operation of the
showcase, for extended periods, outside of this
Nameplate
Joint
Plug*
Slider
Food Mount
Fig. 1
WARNING
IMPORTANT
IMPORTANT
normal temperature range may affect cooling
performance.
Hose
For best operating results:
* The showcase should not be located next to ovens,
grills or other high heat producing equipment.
* The location should provide a firm foundation for
the equipment across its entire bottom surface. Any
unevenness or the insertion of packing resulting
in only partial contact could result in the case
becoming damaged or deformed causing a failure.
The showcase should always be level from side to
side and back to front.
No good
If the foundation is not firm enough, it may warp
and cause some space between its center and the
showcase bottom. In this case, provide a support to
keep the foundation level.
No good
* Avoid a site where dripping is not allowed.
* Do not expose the showcase to direct sunlight or
higher temperatures to prevent damage to the plastic
housing.
* Allow at least 15 cm clearance between the
Condenser air outlet and the wall or other equipment
for proper air circulation. The rear and top of the
showcase should have enough space (at least 100
cm) for proper air circulation and smooth operation.
Air Outlet
100cm
3
ENGLISH
Good
Fig. 2
Good
Support
Fig. 3
Air Inlet
100cm
Unit Height
15cm
Fig. 4

Publicité

Table des Matières
loading

Table des Matières