Kenmore 253.6000 Serie Guide D'utilisation Et D'entretien page 12

First Steps
18. Should open seal condition exist, try
to massage the gasket to make sure it
is seated into the channel.
IMPORTANT
If the condition still exists, try heating the
gasket with a hair dryer with the door
closed. Use Caution and be careful not
to damage the interior door panel or
gasket by applying too much heat.
19. If the open seal condition still exists, it
may be necessary to flip the gasket.
In this case, remove the gasket from
the door by pulling it out. Rotate the
gasket half a turn (180 degrees).
Reinstall the gasket by inserting the
corners first then work towards the
middle assuring that it is fully seated
in the channel.
20. Flip toe grille and reinstall.
21. Plug in electrical power cord and
turn refrigerator temperature control
to center position. Adjust setting as
necessary.
Handle Installation/Removal
IMPORTANT
There are instructions for two handle styles
on the following pages. To ensure proper
installation of both handle styles, review
these instructions and pictures thoroughly
prior to handle installation.
Additionally, before installing handles,
make sure the door swing is correct. See
the Door Removal/Reversal instructions
in this Use & Care Guide.
CAUTION
Wear gloves and use extreme CAUTION
when installing these handles. The rounded
end of the handles may be sharp.
Handle Style 1 (Plastic Handles)
To attach refrigerator handle:
1. Place bottom of handle over
mounting screw and pull up while
holding the handle at an angle
towards the side of the door.
2. Rotate the handle over the corner of
the door until handle is aligned with
screw holes on top of door.
3. Secure top of handle with two screws
provided.
12
Screws
Handle
Base
Handle