Perel LEDA4011RGB Mode D'emploi page 6

Mounting the Lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket to determine the location of the mounting
holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
4. Connect the power cable to a suitable junction box (not incl.). Make
sure the connection is properly earthed. Make sure there is no strain
on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges using a
hex key.
6. Tilt the lamp in the desired angle and tighten the hinges.
6. Remote Control
ON/OFF
/
FADE
FLASH
SMOOTH
STROBE
RGB
V. 02 – 06/06/2016
LEDA4011RGB/LEDA4012RGB
switch on/off
increase/decrease brightness
7-colour gradual range
3-colour flashing
3-colour gradual change
7-colour flashing
single colour selection
L = line, brown
E = earth, yellow/green
N = neutral, blue
6 ©Velleman nv