GreenWorks 2101202CT Manuel Du Propriétaire page 18

OPERATION
INSTALLINg STRINg IN STRINg HEAD (See Figure 11.)
1. Line up the slots on the spool cap with the slots
on the string head.
2. Insert line through the string head hole. Push line
until it exits the opposite string head hole.
3. Pull the line through until there is an equal
amount of line on each side.
4. Turn the spool cap clock-wise to begin
winding the string into the string head. Leave
approximately 5 inches of string protruding out of
each side of the head.
It is recommended that .080" line Diameter be used
for this string head.
Note: Do not put more than 15 feet of line in at a time.
REmOVINg OLD TRImmER LINE (See Figure 12.)
1. firmly press in the tabs on each side of the spool cover.
2. Remove the spool cover from the spool housing.
3. Remove any excess trimmer line or obstructions from the spool.
4. Use a clean cloth to wipe away any debris from the spool, spool cover, or spool housing.
5. Align the tabs of the spool cover with the posts on the spool housing. Push the spool cover
until the tabs securely snap into the posts.
SPOOL COVER
SPOOL HOUSINg
Spool Cap
String Head
18
Slot
String Head Hole
Fig. 12
s
Slot
s
Fig. 11