Publicité
Les langues disponibles
Les langues disponibles
inside the appliance, as they could leak or release fluids.
CAUTION — A damaged power cable should be immediately replaced by
the manufacturer or by a qualified retailer, in order to avoid any risk of
electric shock.
CAUTION — Keep the ventilation openings well open and ensure that air
can circulate, especially if the appliance is recessed into a wall.
CAUTION — Do not damage the refrigerating circuit.
CAUTION — Do not use electrical appliances inside the compartment
unless they are tolerated by the manufacturer.
CAUTION — The refrigerating and insulating systems contain
inflammable gases. When the appliance is scrapped, it should be
deposited at an accredited collection center. Do not expose the
appliance to fire.
Refrigerating fluid
The refrigerating circuit in the appliance uses refrigerating isobutane (R600a), which is a highly
inflammable natural gas and is therefore dangerous for the environment. When transporting installing the
appliance, ensure that no element of the refrigerating circuit is damaged. The refrigerating fluid (R600a) is
inflammable.
Caution: Fire rise
If the refrigerating circuit is damaged:
▪
Avoid open flames or any source of combustions
▪
Ensure that the room in which the appliance is installed is well ventilated. It is dangerous to change
the specification of the appliance in any way whatsoever.
Damage to the power cable may cause a short circuit and/or electric shock.
Electrical safety
▪
We decline any liability in respect of incidents caused by poor electrical installation.
▪
Do not extend the power cable. Do not use an extension cable, or adapter, or multi-way socket.
▪
Check that the wall socket is not damaged. A wall socket in poor condition may cause the
appliance to overheat and explode.
▪
Check that the wall socket used for the appliance is properly accessible.
▪
Never pull on the main power cable.
▪
Ensure that the appliance is always electrically earthed.
▪
If the wall socket is loose, do not connect the cable, as there is a risk of electric shock or fire.
▪
Do not use the appliance if the interior lighting cover is not installed.
▪
Disconnect the appliance before replacing the lighting bulb.
▪
The appliance operates on a single phase 220~240 V / 50 Hz power supply.
▪
The appliance must be connected to an earthed wall socket, in accordance with applicable
20
Publicité
