Makita GA036G Manuel D'instruction page 10

For depressed center wheel, flap disc,
flex wheel, wire wheel brush / abrasive
cut-off wheel, diamond wheel
1. While pushing the lock lever, mount the wheel
guard with the protrusions on the wheel guard aligned
with the notches on the bearing box.
1
► 1. Lock lever 2. Notch 3. Protrusion
2.
wheel guard by holding down the portions B as shown
in the figure.
B
3
2
► 1. Wheel guard 2. Hole
NOTE: Push down the wheel guard straight.
Otherwise, you cannot push the wheel guard
completely.
10 ENGLISH
While pushing the lock lever toward A, push in the
B
A
1
2