Olimpia splendid PELER 6C Instructions Pour L'installation, L'emploi Et L'entretien page 49

3.3.a - Preliminary operations
• Place the appliance on a stable and not inclined base, at least 15
cm. from the wall or from any other object, in order to ensure the
correct air circulation. Place it on a water-resistant surface since the
possible water leakage could damage furniture or the floor.
• Do not place the appliance directly on carpets, towels, blankets or
other absorbent surfaces.
• Insert the plug in the power socket; the appliance beeps and the
display shows room temperature in °C.
Before electrically connecting the appliance, make sure the plate data
correspond to those of the electricity distribution network.
3.3.b - Filling
It is necessary to add water in the tank (7) before the cooling/humidifier
function is activated.
Water can be added from the upper part of the appliance or by removing the
water tank (7):
- To add water from the upper part, open the lid (1) (fig. G), slowly pour
water in the compartment (7), then close the lid (1) again.
- To remove the water compartment (7) from the body of the appliance
(Fig. H):
• Press the hook (6) and slide out the compartment (7);
• Pour water into the compartment (7);
• Replace the compartment (7) in the appliance.
• Check the water level in the tank (7) through the water
level gauge (12) (fig.L).
• Do not fill the tank (7) beyond the maximum indicated level.
• Always use clean water.
• The appliance could produce a slight smell or the water in the tank (7)
could be slightly coloured during first use; this events are normal and
absolutely harmless for the user's health.
EN - 16
PELER 6C