Switching Off; Cleaning And Maintenance - Sanitas SHK 28 Mode D'emploi

ON/OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds it is pos-
sible to switch it on again.

4.6 switching off

To switch the heating pad off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
NOTe:
If the heating pad is not in use, switch the side sliding switch for ON/OFF to setting "0" (OFF) and
unplug the mains plug from the socket. Then disconnect the controller from the heating pad by un-
plugging the plug-in coupling.

5. cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller
from the heating pad by unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
cAuTION
• The controller must never come into contact with water or other liquids, as this may cause damage.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the heating pad can be removed with a damp cloth and if necessary, with a little liquid
detergent for delicate laundry.
cAuTION
• Please note that the heating pad may not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed.
This heating pad is machine-washable. Set the washing machine to a particularly gentle wash cycle at 30°C
(wool cycle). Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
cAuTION
• Please note that frequent washing of the heating pad has a negative effect on the product. The
heating pad should therefore be washed in a washing machine a maximum of 10 times during its
life.
Immediately after washing, reshape the heating pad to its original dimensions while it is still damp and spread
it out flat on a clothes horse to dry.
cAuTION
• Do not use pegs or similar items to attach the heating pad to the clothes horse. Otherwise the
heating pad may be damaged.
• Do not reconnect the switch to the heating pad until the plug-in connection and the heating pad are
completely dry. Otherwise the heating pad may be damaged.
13