Operating Instructions - GE AEM08 Série Manuel D'utilisation Et Instructions D'installation

About the controls on the air conditioner.
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Light indicates the unit is in the
temperature or delay time Set mode.
Power
On/Off
Auto
High
Med
Low
Fan Mode
NOTE: The display always shows the room temperature except
when setting the Set temperature or the Delay timer.
Air Conditioner Controls
Controls
Power Pad
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
Temp Increase
Use to set temperature when in Cool or
Energy Saver mode. The Set light will turn on
while setting.
Delay Timer Increase
(–) Pads
Each touch of the Increase
pads on the unit or the Increase
–
pads on the remote control will set the delay
time when using the Delay 1–24hr timer. The
Set light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit. NOTE: On the remote
control, use the fan speed Increase
Decrease
Med or High. Use the Auto pad to turn Auto
fan on.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to
degree Celcius (°C), press the Temp Increase
4
seconds. Repeat the process to change back to degree Fahrenheit (°F)
+
Set
-
Cool
Fan Only
Energy Saver
Reset Delay
Filter 1-24 Hrs
/Decrease
(+) /Decrease
/ Decrease
+
–
pads to set the fan speeds to Low,
Light indicates the
delay timer is set.
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
8
set Increase
and Decrease
Mode Pad
Use to set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads/Delay 1-24hr Pad
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
it can be set to automatically turn off in 1 to
24 hours.
Pads
How to set:
Press the Delay 1–24hr pad on the unit or the
Delay pad on the remote control. Each touch
of the Increase
unit or the Increase
the remote control will set the timer in 1-hour
intervals. The Set light will turn on while setting.
/ Decrease
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on
the unit or the Delay pad on the remote control.
Use the Increase
unit or the Increase
remote control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad
+
/
until the light on the Delay 1–24hr pad goes off.
Reset Filter
LED will turn on when fan has accumulated 250
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset
the accumulated run time.
and Temp Decrease
Fan Fan
Remote Control
When the air conditioner is off, it can
When the air conditioner is on,
/ Decrease pads on the
+ –
/ Decrease pads on
/ Decrease pads on the
+ –
/ Decrease pads on the
buttons together and hold for 3
Delay
timer
Increase
Auto Fan
on
Fan speed
Increase
Unit power
on/off