ALDEN KITECO SUNPOWER FLEX BLACK Guide D'installation page 16

Warnings
The reproduction of whole or part of this guide is strictly forbidden without Alden's agreement.
ALDEN declines all responsibility in the event of incidents or accidents if they are due to a non observation of the
installation instructions or the way the product is used.
Alden draws your attention to the risks that may occur if the mounting is not correct. Alden declines all responsability
if the product is not mounted in the correct way and especially if it is installed by a non professional person.
The retailer is ment to know installation rules and to apply them. He will especially respect the installation location,
the cable connection, the gluing and screwing. By selling and installing an Alden product, the retailer is obliged to
inform his customer on how the product works and perhaps how to install the product in some cases. He will also
give the customer all relevent documents. The retailer will inform the customer about security matters. The retailer
must inform the end user on how to use an Alden product and safety measures. The product is to be used only for
the intended matter. The retailer must also inform the end user about the current laws applicable in the country
where the product is going to be used.
Each product with electronic components has to be protected from undervoltage (under 10,5 volts) and overvoltage
(over 15 volts).
It is strictly forbidden to open, interfer, repair and/or modify the product without Alden's agreement. The warranty
will no longer be applicable if you undertake such an action.
Remove the fuse from the electric circuit board of the regulator before interfering on the general circuit board, or
changing or connecting the battery. If the vehicle is equipped with a satellite system, also remove the fuse from
the electric circuit board of the satellite system and the receiver.
You must always use the provided cables and do not cut them nor alter them. If you chose to ignore this warning,
you may cause serious damage and the warranty will no longer be applicable.
You must install separate cables, with a fuse on the plus line, directly from the battery cell to connect the regulator.
16
• By installing this product you accept the previous rules. •
ALD-15138