Danby DPA053B4WDB Manuel Du Propriétaire page 16

OPERATING INSTRUCTIONS
CONTROL PANEL
1. Mode button:
• Press to select the desired mode.
• Press and hold for 3 seconds to activate the
continuous fan.
2. Cool mode indicator light: Illuminates when
cooling mode is activated.
3. Fan mode indicator light: Illuminates when fan
mode is activated.
4. Dry mode indicator light: Illuminates when dry
mode is activated.
5. LED Display: Shows the set temperature in °C or
°F or the auto-timer settings.
6. Power indicator light: Illuminates to indicate that
the appliance has power.
7. Timer indicator light: Illuminates when the timer
is activated.
8. Continuous fan indicator light: Illuminates when
the continuous fan is activated.
9. Temperature control buttons:
• Used to set the temperature.
• Press and hold both temperature control buttons
for 3 seconds to change the temperature display
from °C to °F.
10. Power Button: Press to turn the appliance on or
off.
2
1
3
4
10
9
5
8
6 7
OPERATING MODES
Cool Mode
Choose cool mode to set the cooling function.
• Use the temperature control buttons to choose
the desired temperature.
• Use the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 17
- 30°C (62 - 86°F).
• The exhaust hose should be installed during cool
mode to ensure the best results.
Dry Mode
Choose dry mode to remove excess moisture from
the air. Water will condense inside the appliance
and drain out the back.
• The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• The exhaust hose does not need to be installed
during dry mode.
• It may be necessary to install the continuous
drain hose during dry mode to remove excess
water.
Fan Mode
Fan mode can be used to run the fan without
engaging the cooling or dehumidifying functions.
• Press the fan button to choose the desired fan
speed.
• The exhaust hose does not need to be installed
during fan mode.
• In cooling or dry mode, press and hold the
mode button for 3 seconds to set the fan to run
continuously. Press and hold the fan button for 3
seconds to disengage the continuous fan. During
normal operation the fan will turn on and off
with the compressor.
Auto Mode
Auto mode is a pre-set factory program that
automatically defi nes the mode (cool or fan) and
fan speed based on the set temperature and the
ambient temperature. The exhaust hose should be
installed during auto mode. Auto mode can only be
activated from the remote control.
15