Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting the Time (M1733N)
Your microwave oven has an inbuilt clock. The time can be displayed
GB
in either the 24-hour or 12-hour notation. You must set the clock:
•
When you first install your microwave oven
•
After a power failure
Do not forget to reset the clock when you switch to and from
summer and winter time.
1. To display the time
in the...
24-hour notation
12-hour notation
2. Set the hour with the h button and the minutes with the
min button.
3. When the right time is displayed, press the
again to start the clock.
Result :
Then press the
button...
Once
Twice
button
The time is displayed whenever you are not
using the microwave oven
What to Do if You are in Doubt or Have a
Problem
If you have any of the problems listed below try the solutions given.
This is normal.
•
Condensation inside the oven
•
Air flow around the door and outer casing
•
Light reflection around the door and outer casing
•
Steam escaping from around the door or vents
The oven does not start when you press the
•
Is the door completely closed?
The oven does not start when you turn the TIMER knob.(M1713N)
•
Is the door completely closed?
The food is not cooked at all
•
Have you set the timer correctly and/or pressed the
•
Have you set the timer correctly? (M1713N)
•
Is the door closed?
•
Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered?
The food is either overcooked or undercooked
•
Was the appropriate cooking length set for the type of food?
•
Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing)
•
Have you used a dish with metal trimmings?
•
Have you left a fork or other metal utensil inside the oven?
•
Is aluminium foil too close to the inside walls?
The oven causes interference with radios or televisions
•
Slight interference may be observed on televisions or radios when the
oven is operating. This is normal.To solve this problem, install the oven
away from televisions, radios and aerials.
•
If interference is detected by the oven's microprocessor, the display may
be reset. To solve this problem, disconnect the power plug and reconnect
it. Reset the time. (M1733N)
If the above guidelines do not enable you to solve the problem,
contact your local dealer or SAMSUNG after-sales service.
6
button.(M1733N)
button?(M1733N)
Publicité
Chapitres
Table des Matières
