Using The Remote Control - Haier ESA415M Guide D'utilisation Et D'entretien

USING THE REMOTE CONTROL

FILTER RESET
This feature automatically notifies you that the air filter must be cleaned. The
indicator light will come on after 240 hours of operation. Clean the air filter (refer
to Care and Cleaning), place it back in the front panel, and press the Filter Reset
button. The light will turn off.
NOTE: The raised dots are Braille for the visually impaired. (See Fig.19)
Remote control may differ in appearance from the image shown.
NOTE: Remove and discard protective film prior to use. The remote control runs
on one CR2025 battery (included). Replace battery after 6 months of use,
or when the remote control starts to lose power. To change battery, first remove screw on
back panel of remote.
POWER
Press ON/OFF to turn on the air conditioner.
Mode
Press MODE to choose Fan, Cool, Energy Save or Dehum.
Speed
Press SPEED to choose High, Med, Low or Auto Cool.
TIMER
To set the air conditioner to turn off after a set amount between 1 hour and 24 hours (unit must
be ON):
1. Press TIMER. Timer OFF indicator light on the air conditioner control panel will flash.
2. Press the TEMP/TIME up or down arrow button to change the delay time from 1 hour to 24
hours.
3. After 5 seconds, Timer OFF indicator light on the air conditioner control panel will remain on.
TO SET TIMER TO TURN ON THE AIR CONDITIONER, KEEPING PREVIOUS SETTINGS:
1. Turn on the air conditioner.
2. Press TIMER. Timer On indicator light on the air conditioner control panel will flash
3. Press the TEMP/TIME up or down arrow button to change the delay time from 1 hour to 24
hours.
4. After 5 seconds, Timer On indicator light on the air conditioner control panel will remain on.
USING YOUR AIR CONDITIONER
ON/OFF
MODE
SPEED
TIMER
TEMP/TIME
TEMP/TIME
PAGE 25