During Vacuuming; Park System For Pauses Whilst Vacuuming; Park System For Storage - Miele Compact C1 Mode D'emploi

The floorhead will be easier to mano-
euvre. Close the valve when you are
ready to use full power again.
During vacuuming (dia. 24)
^ When vacuuming, pull the cleaner
behind you on its wheels. You can
stand it upright for vacuuming stairs
and curtains etc.
,
When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain
conditions these charges will be
released. To avoid the unpleasant
effects of these discharges, a metal
inlay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming.
Setting down, transportation
and storage
Park system for pauses whilst
vacuuming (dia. 25)
The Park system allows you to
conveniently park the suction tube and
floorhead during pauses.
^ Slot the floorhead into the parking
attachment at the back of the
vacuum cleaner.
If your vacuum cleaner is on a
sloping surface, e.g. a ramp,
- retract the telescopic tube fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction tube.
Park system for storage (dia. 26 + 27)
,
Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
If your vacuum cleaner has an
EasyLock suction tube you can
separate the two sections for storage
purposes.
^ Press the release button on the lower
section and pull the top section out.
^ Push the connection piece attached
to the upper tube into the lower tube.
^ Stand the vacuum cleaner upright.
If your vacuum cleaner has a
telescopic tube, retract the tubes fully
so that it takes up less room for
storage.
^ Slot the floorhead downwards into the
parking attachment on the side of the
vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.
en
35