en-US
1
Lowest power level
for light soiling
2
Medium power level
for normal soiling
Max.
Highest power level
for heavy soiling
The floor covering detection function is
activated in the medium and highest
power levels.
The Electrobrush power output is auto-
matically set to the optimum level
based on the type of flooring – this can
lead to a change in the operating noise.
Illuminating the work area
(depending on model)
The Electrobrush on your vacuum
cleaner is equipped with BrilliantLight to
illuminate the work area.
Self-standing function for short
pauses in vacuuming
(For safety reasons, this function can
only be used when the PowerUnit is fit-
ted at the bottom of the vacuum
cleaner)
If you are vacuuming with the
PowerUnit fitted at the bottom of the
vacuum cleaner, you can easily inter-
rupt operation while the appliance is
switched on.
Swing the vacuum cleaner forwards
until the Electrobrush connector audi-
bly clicks into place.
The vacuum cleaner stays securely up-
right, the Electrobrush switches itself off
and the battery is conserved.
22
If you then unlock the connector on the
Electrobrush, the Electrobrush will
switch on again.
Maintenance
Risk of injury caused by rotating
roller brush.
You can injure yourself on the rotat-
ing roller brush.
Switch the vacuum cleaner off before
doing any maintenance work. Use
the On/Off switch on the Comfort
handle to do this.
Replacement parts are available from
your Miele dealer or through Miele
Service.
Emptying the dust
container (Fig. 30–34)
Empty the dust container before the
dust has reached the max marking on
the dust container.
Turn the lid of the dust container in
the direction of the arrow as far as
the first stop.
Remove the dust container upward.
The contents of the dust compartment
can be disposed of with the normal
household trash, providing it contains
general household dust only.
Hold the dust container close to the
trash can so that as little dust as pos-
sible excapes.
Turn the lid of the dust container in
the direction of the arrow as far as
the next stop.