Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
28 www.aeg.com
Problem
The compressor
does not start imme-
diately after press-
ing the COOLMATIC
or FROSTMATIC
switch, or after
changing the tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on
the Display.
Possible cause
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The temperature regula-
tor is not set correctly.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode
(dEMo).
Solution
Decrease the room tem-
perature.
The compressor starts af-
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Set a higher/lower temper-
ature.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
Publicité
Chapitres
Table des Matières
