AEG SKS71040F0 Notice D'utilisation page 26

26 www.aeg.com
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and
save electricity consumption.
5.2 Defrosting of the refrigerator
5.3 Defrosting the freezer
A certain amount of frost will al-
ways form around the top com-
partment.
Defrost the freezer when the
frost layer reaches a thickness of
about 3-5 mm.
To remove the frost, do these steps:
1. Switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put
it in a cool place.
3. Open the door.
4. When defrosting is completed, dry
the interior thoroughly.
5. Switch on the appliance.
6. Set the temperature regulator to ob-
tain the maximum coldness and run
the appliance for two or three hours
using this setting.
Take care of not to damage the
cooling system.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason it is recommended
that the outer casing of this appliance is
only cleaned with warm water with a little
washing-up liquid added.
After cleaning, reconnect the equipment
to the mains supply.
Frost is automatically eliminated from
the evaporator of the refrigerator com-
partment every time the motor compres-
sor stops, during normal use. The de-
frost water drains out through a trough
into a special container at the back of
the appliance, over the motor compres-
sor, where it evaporates.
Periodically clean the defrost water drain
hole in the middle of the refrigerator
compartment channel to prevent the wa-
ter overflowing and dripping onto the
food inside. Use the special cleaner pro-
vided, which you will find already inser-
ted into the drain hole.
7. Reload the previously removed food
into the compartment.
WARNING!
Never use sharp metal tools to
scrape off frost from the evapo-
rator as you could damage it. Do
not use a mechanical device or
any artificial means to speed up
the thawing process other than
those recommended by the
manufacturer. A temperature rise
of the frozen food packs, during
defrosting, may shorten their
safe storage life.
5.4 Periods of non-operation
When the appliance is not in use for
long periods, take the following precau-
tions:
• disconnect the appliance from elec-
tricity supply
• remove all food