Publicité
Les langues disponibles
Les langues disponibles
• Clean the blade (3) on both faces as indicated in the
drawing.
If the sliding carriage stops sliding smoothly, lay the
machine on its side.
Cleaning the slide bar (29) and lubricate it with Vaseline
or industrial oil.
BLADE SHARPENING
If the appliance does not slice well and blade is blunt,
blade should be sharpened by qualified staff.
N.B.: it should be noted that the blade is highly resistant,
therefore it needs to be sharpened only when the
capacity of cut decreases. The gauge plate or guard
plate shall be closed on slicers with an integral blade
sharpener during the sharpening operation.
• Unplug. • Check that the movable bulkhead is closed
(graduated knob (6) in position "0"). • Carefully clean the
part of the blade to be sharpened. • Reinsert the plug. •
Loosen the locking knob (23) of the sharpener group
Publicité
