Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USE
·
Let the machine run for 24 hours when you use it for the first time.
·
The machine is designed to work in an environment with a temperature between 5°C and 35°C.
·
If the machine is turned off and turned on again quickly, give the machine approximately 3 minutes to
4
restart correctly.
·
Do not connect the dehumidifier to a shared outlet which is used for other devices.
·
Choose a suitable location with an easily accessible outlet.
·
Connect the machine to an earthed outlet, where the voltage is consistent with the voltage listed on
the machine.
·
Make sure that the water reservoir is in the correct position, otherwise it will not work properly.
CONTROL PANEL
1. On/Off Button
Press this button to turn the dehumidifier on and off. When you turn the machine on, the 'power' light will
turn on and the display will show the air humidity percentage at the moment.
2. Mode
This button allows you to choose from 4 settings:
Dehumidify
The air humidity can be set from 35% relative humidity to 85% relative humidity at 5% intervals. For dryer
air, press "-" and set the air humidity to a lower percentage. (min. = 35)
For moister air, press "+" and set the air humidity to a higher percentage. (max. = 85)
The ideal humidity in the house falls approximately between 40% and 60%.
PC
There will be no indicator light with this setting.
VC PC
9448HK
()
Dryer function
002
With this setting, the dehumidifier operate at maximum capacity. The ventilation speed is high. Select
this setting to dry moist clothes more quickly. Position the dehumidifier with the air exhaust aimed at the
QMK-J53.028) PVC PC General Technical Conditions for Labeling Parts
clothes. Leave approximately 30 to 50 cm between the appliance and the clothes.
036.1013(QMK-J53.028) PVC PC General Technical Conditions for Labeling Parts;
clear side cut without any defect;
, vaporific effect, black spot, white spot and other impurities;
Caution: do not cover the openings of the appliance. A lack of air circulation can cause overheating and
e colors shall be inspected according to sealed sample.
back of finished pieces shall
fire. Make sure that no water gets into the appliance; this may cause electrical shocks.
8HK ) and the undimensioned glue is (). The coverage of self-adhesive coating shall comply
be attached firmly with light pressure.
The "Dryer" indicator light will light up.
Level (6), SJ/T10628 Plastics Dimensional Tolerance;
002 Technical Standard for Restricted Hazardous Substance in the Products of MIDEA.
.1008 Technical Standard for REACH of MIDEA.
36
DO343DH
4
5
6
3
4
5
6
7
8
7
6
5
16020100000057
.
DESIGN
20180315
CO.BY
PROESS
STANDARD
APPROVE
AUTHORIZE
7
8
9
1
2
EU-CFZ0.6BD/N3-DF(A3)
MODEL
(RoHS)
PART
REV NO
WEIGHT
REL
.
S
K
1
1
TOTAL SHEETS
.
NO OF SHEETS
9
10
PART NO
MATERIA
SCALE
1:1
Guangdon
10
Publicité
Table des Matières
