Electrolux ERD 165 C Notice D'utilisation page 25

Problem
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
There is no cold air circu-
lation in the appliance.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Make sure that there is cold
air circulation in the appli-
ance.
25