HQ Power VDL250FL Mode D'emploi page 2

• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture. Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) Fixture
1. handle
2. fan
3. housing
4. mirror
5. effect switch
6. fuse holder
7. housing screw
b) Lamps
Always disconnect the main power and allow the fixture ample time to cool down before attempting to replace the
lamp. Remember that you have to replace the lamp with the same type of lamp.
1. Be sure to follow the right procedure when handling halogen lamps. Never touch the new lamp with your bare
fingers.
2. Tweak the screws located on the bottom of the unit.
3. Remove the lamp cover to expose the lamps.
4. Remove and replace the lamps.
5. Reassemble in reverse order.
Remark: Do not operate the device when the cover is open.
c) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse-holder above the power-supply.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
VDL250FL 2 VELLEMAN