Hansgrohe Ecos 32126000 Mode D'emploi / Instructions De Montage page 4

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The mixer can not used together with a continuous
flow water heater.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
4
max. 1MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Assembly (see page 32)
English
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 34)
Set hot water limiter
Dimensions (see page 31)
Flow diagram (see page 31)


Operation (see page 35)
• Due to the design of the Bidette fittings,
• Hansgrohe recommends not to use as
Spare parts (see page 37)
Special accessories
(order as an extra)
seal #98996000 (see page 32)
Cleaning (see page 36)
Rate of flow mixer
Rate of flow Hand shower
a small amount of water will leak at the
outlet of the fitting when the hand shower
is running.
drinking water the first half liter of water
drawn in the morning or after a pro-
longed period of non-use.