Troubleshooting - HTC 280 Manuel D'utilisation

• Examine the grind holder for damages and the wear
of the rubber cylinders (B).
The product does not start
• Make sure that the power supply and the power
cords are not damaged.
• Examine the emergency stop button, turn the button
clockwise to release the emergency stop.
• Examine the overload lamp. If the overload lamp is
on, let the motor cool down for some minutes until
the product is automatically reset.
The product is not easy to hold on to
• Too small number of diamond tools are installed on
the product.
• The selected type of diamond tool is not correct for
the surface.
• High current is used by the motor for the operation.
• Use the number of diamond tools that is
recommended to decrease the force on the product
and the operator. Refer to
on page 10 .
The product has sudden movements
• Make sure that all diamond tools are installed
correctly and that all have the same height.
917 - 001 -
A
B

Troubleshooting

Metal bond diamond tools
• Replace the rubber cylinders if it is necessary.
The product stops after only a while
• If the product overloads, the overload protection
engages and stops the motor.
• Decrease the load. The lower hole is for a higher
handlebar and increased grind pressure. The top
hole is for a lower handlebar and decreased grind
pressure.
• The product restarts after approximately a minute,
when the temperature of the motor is decreased to
usual level.
• Make sure that the extension cables are not too
short.
The product stops during startup
Correct voltage supply is necessary for a good motor
performance. Too long extension cables and/or a too
small gage decreases the power of the motor during
operation.
• If the motor overloads, the overload lamp comes on.
Wait 2 minutes and try again. When this does not
help, speak to an approved service workshop.
• Make sure that the extension cables are not too
short.
15