Perel TC78070 Mode D'emploi page 4

4. Installation
Install vertically on a flat, dry, stable and non-slippery surface.
5. Operation
5.1 The Thermostat
Insert the power plug into the mains.
Turn the thermostat knob fully to the right.
Switch on the heater by selecting the power.
When the room has reached the desired temperature, turn the thermostat knob to the left until
the heater switches off. The temperature is now set and the heater will automatically switch
on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
When the appliance is switched off (with supply cord in socket), the fan will keep blowing until
the appliance is cooled down.
5.2 Overheating Protection
This heater is equipped with an overheating protection, which will automatically switch off the
heater in case of overheating. If this occurs, please unplug from the mains and allow cooling
for 30 minutes before re-connecting and switching on again.
To avoid overheating, check that the appliance is sufficiently ventilated and that the air intakes
are unobstructed. Please contact your local dealer if the heater keeps switching off.
V. 07 – 24/11/2020
TC78070
4 ©Velleman nv