Kicker KM Série Mode D'emploi page 3

Free Air Mounting: The Free-Air subwoofers (KMF10, KMF12) do not require an enclosure,
however, it is important to isolate the sound coming off the front of the driver from the sound
radiating from the back of the driver. This isolation is usually accomplished by using the driver in a
factory speaker location, or in a location with a semi-isolated rear chamber.
Infi nite Baffl e Mounting: The infi nite baffl e mounting method
effectively utilizes the storage space of most boats. Use caution
when mounting speakers through any panel of the boat. Please
be aware of wiring harnesses, springs, hinges, and folding seat
mechanisms that may interfere with the operation of the boat or
speaker system. Mark the panel for the hole cut-out diameter of the
subwoofer and cut the hole.
Storage Space
B
Sealed Enclosures: KM subwoofers perform
well in any size sealed enclosure between the
minimum and maximum volume recommendations.
These systems will exhibit benefi ts of both designs:
Smaller enclosures will produce tight punchy bass,
while the larger enclosures will deliver extended
low-frequency performance.
C
These enclosure recommendations have been
calculated with the airspace inside the enclosure
and include the displacement of the woofer.
A
Pro Tip: You are one KXM Amplifi er and a few cables away from a complete, high-quality system
with rock-solid bottom end as only available from KICKER! Please ask your dealer about KICKER
KXM amplifi er upgrades.
3