Kicker KM Série Mode D'emploi page 2

Authorized KICKER Dealer:
Purchase Date:
Speaker Serial Number:
MODEL:
Rated Impedance [Ω]
Fs [Hz]
Sensitivity [1W, 1m]
Qts
Qms
Qes
Re [4Ω]
Vas [ft³, L]
Xmax (Linear Excursion) [mm]
Continuous Power Handling [Watts RMS]
Outer Woofer Dimension [in, cm]
Mounting Depth [in, cm]
Mounting Cutout Hole Diameter [in, cm]
Frequency Response [Hz]
INSTALLATION
Wiring: Carefully place the speaker wire in a location that is clear of standing water and moving
components of the boat. The terminal cover is removable for wiring installation and, when locked
in place, it aids in ignition protection. Connect the speaker wire to the speaker terminals. Loop the
positive and negative wires into the pocket in the cover, then together and through the slot.
Remove Terminal Cover
2
KM Subwoofers Owner's Manual
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER,
OR SUBWOOFER IN A DISTORTED, CLIPPED OR OVER-POWERED
MANNER CAN CAUSE YOUR AUDIO SYSTEM TO OVERHEAT, POSSIBLY
CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR
COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4
INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE
MOUNTED WITH AT LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN
THE FRONT OF THE SPEAKER AND ANY SURFACE.
KM10
2 or 4
28.7
86.24
0.419
16.699
0.43
3.64
1.54, 43.75
10.3
175
10-11/16, 27.1 10-11/16, 27.1 12-9/16, 31.9 12-9/16, 31.9
5, 12.7
9-1/4, 23.5
30 - 500
Terminal Cover Pocket
Route wire through
Terminal Cover Slot
KMF10 KM12
2 or 4 2 or 4
46.8 29.9
86.27 88.1
0.655 0.47
9.457 15.331
0.704 0.485
3.62 3.68
.58, 16.540 2.36, 66.96
10.3 10.3
175 175
5, 12.7 5 1/2, 14
9-1/4, 23.5 11, 28
30 - 500 30 - 500
Connect wire to terminals
KMF12
2 or 4
47.5
87.46
0.744
11.044
0.798
3.63
.83, 23.542
10.3
175
5 1/2, 14
11, 28
30 - 500