Clatronic BS 1233 Mode D'emploi & Garantie page 36

5....-05-BS 1233
Cable winding device:
GB
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
Winding:
Press the cable (5) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Nozzle Attachment:
The nozzle attachment is located below the take-up device for the mains lead or
below the outlet filter.
Crevice nozzle/Brush nozzle: For vacuuming upholstery, curtains and in corners
Floor nozzle:
Releasing the nozzles:
Damper
Open the damper on the hose handle to adjust the airflow or to release objects clin-
ging to the nozzle.
Dust bag replacement display (6):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag:
Pull the plug out of the socket. Open the lid of the dust bag compartment by the
handle (9). Remove the dust bag holder and pull the dust bag out of the holder.
Insert a new dust bag. Reinsert the dust bag holder. Close the cover so that it
snaps into place.
36
02.07.2003 14:45 Uhr
and crevices etc.
"2-in-1" nozzle: When this is folded together (as sto-
red in the compartment) it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
To clean carpets or smooth surfaces.
Smooth floors:
Press down the lever with the brush symbol with
your foot. The brush is now visible.
Carpets:
Press down the opposite lever.
Pull these off while turning slightly.
Seite 36