ARTHUR MARTIN ASF8645ROX Notice D'utilisation page 14

14
Using the detergent
A B
C
CAUTION! Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
Setting and starting a
programme
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press repeatedly until the indicator
of the desired programme is on.
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1
to 24 hours).
• The indicator
• The indicator of the selected
programme flashes.
3. Press to begin the countdown.
• The indicator of the selected
programme is on with fixed light.
• For the delay time between 24 and
11 hours, the display shows only
hours. For the delay time between
10 and 1 hour, the display shows
hours and minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme ends. It does not
happen if the door is opened by
AirDry function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, you have
to set a programme and options again.
Press and hold simultaneously
until the appliance is in programme
selection mode.
is on.
is
and